A1 Handheld Engraving Operation Guide

Step 1:  Machine installation

① Install the Handle：Align the handle with the mounting slot on the back of the laser module, then slide it into place until it clicks.
② Install the Protective Cover：Align the protective cover with the four mounting holes on the bottom of the laser module, then insert it into place.
③ Power On the Handle:Press and hold the function button on the bottom of the handle for 3 seconds. When you hear a beep and the indicator on the laser module lights up, the device is powered on and ready for use.

Step 2: Software connection and start carving

① Power on the engraver (laser unit indicator solid yellow), then open the Raymoto app, tap Connect, and select the device name (Raymoto_A1_XXXX) from the Bluetooth list.

② And enable "Handheld Mode" in the settings menu.

③ Tap “Start Creating” to enter creation mode, add images or materials, set the required parameters, and save after confirming everything is correct.

④ After saving, return to the main interface. Tap "More" to enter the My works page. Select the file to be uploaded, tap "…" in the upperright corner to open more settings, then choose "Upload to machine".

⑤ Position the machine at the desired engraving location, then briefly press the handle button to preview the image position. During the preview, press and hold the button again for 5 seconds to start engraving, or briefly press it to cancel the preview.

Note: Before engraving, ensure the working distance is correctly set.

⚠️ Precautions 
1. Do not look directly at the laser outlet. Avoid direct laser exposure to skin to prevent laser burns.
2. Do not touch the laser head during carving. Do not move the whole unit while it is running.
3. Keep the working area well-ventilated. Smoke will be generated when engraving plastic or rubber; exhaust is recommended.
4. Keep flammable materials such as paper and fabric away from the laser path to avoid fire hazards.
5. When using the handheld mode, hold the handle firmly. If any unusual situation occurs, unplug the power handle immediately.
6. Do not run handheld engraving without on-site supervision.