A1 Handheld Engraving Operation Guide

Step 1:  Machine installation

① Install the Handle：Align the handle with the mounting slot on the back of the laser module, then slide it into place until it clicks.
② Install the Protective Cover：Align the protective cover with the four mounting holes on the bottom of the laser module, then insert it into place.
③ Power On the Handle:Press and hold the function button on the bottom of the handle for 3 seconds. When you hear a beep and the indicator on the laser module lights up, the device is powered on and ready for use.

Step 2: Software connection and start carving

① Power on the engraver (laser unit indicator solid yellow), then open the Raymoto app, tap Connect, and select the device name (Raymoto_A1_XXXX) from the Bluetooth list.
② And enable "Handheld Mode" in the settings menu.

③ Tap “Creation” to enter creation mode, add images or materials, set the required parameters, and save after confirming everything is correct.

④ Click “My File,” select the file you want to engrave (the file must be saved by the user in advance), select the file you want to engrave and click “Upload File.” Once the upload is complete, click “Close.”

⑤ Place the machine at the desired engraving position, then briefly press the handle button to preview the image location. After previewing, press and hold again for 3 seconds to begin engraving. To cancel engraving, press and hold for 5 seconds.

Note: Before engraving, ensure the working distance is correctly set.